PrintClose   
                

Furukawa HCR1200

GDT Trading Ltd

Dave Tallman
PO BOX 53011
Edmonton, Alberta, T5N 2L4
Canada
OFFICE +1 780 443-3777 FAX +1 780-443-4228
TOLL FREE 888-443-3777
LANGUAGES SPOKEN English
Contact DealerSend to a FriendShow All Pics (2)
SAY YOU SAW THIS ON EQUIPMENTLOCATOR.COM!!!
AVAILABILITY AND PRICE SUBJECT TO CHANGE AND/OR PRIOR SALE. SPECIFICATIONS AND EQUIPMENT CONFIGURATION IS SUBJECT TO CHANGE. PLEASE CONSULT A SALES PROFESSIONAL TO ENSURE THAT WEBSITE INFORMATION IS CORRECT AND UP-TO-DATE.
EQUIP. LOCATION
Edmonton, Alberta, Canada
STOCK #18518CATEGORYFor SaleEST HOURS5965
MAKEFurukawaSTATUSOn YardPRICE
129500 CAD
99055
MODELHCR1200CLASSUsed
YEAR2009AVAILABLEImmediately
NOTES
  • Furukawa
    HCR 1200
    Year 2009
    Current hours 5965

    Hammer was re-bearing and resealed at 5637 hours

    5776 hours,$57,391.51 work order was performed
    1) Service machine:
    - Service eng
    - Oil samples
    - Change final drive oils
    - Change compressor filters

    2) repair and tidy wiring on machine:
    - install and wire in rear lights
    - engine temp sender
    - a/c clutch wiring repairs
    - repair pre heater
    - re-wire alternator wiring
    - repair turbo boost sensor
    - repair ground for fuel guage

    3) Repair broken Console

    4) Misc body work
    - repair hood and bolt down
    - repair bent steps
    - repair bent rear guard
    - remove rear doors,weld/paint/fix door frame/install doors
    - repair boom support on hood
    - repaired broken mirror

    5) Re & Re wiper motor,replace with new

    6) Replace stereo

    7) Repair window latch and adjust door handle

    8) Blow out heater and repair defrost switch

    9) Clean heater AC system,recharge

    10) Replace broken/cracked window

    11) Trouble shoot and repair engine oil leaks

    12) Repaired engine intake heater

    13) Take apart hose minder

    14) Disassemble boom parts / inspect make parts list / repair

    15) Disassemble and inspect front and rear clamps / repair

    16) Trouble shoot and fix dust collector purge jet system

    17) Replace rod swing cylinder bushings and pins

    18) Replace boom lift cylinder

    19) Replace rod changer carosol grease seals

    20) Install new bushings on cylinder for till boom

    21) Install new bearing and grease seals for wheels on hose rail

    22) Changed front hose roller bearings

    23) Feed chain bushings and bearing replaced

    24) Hammer and hose minder wear plates and roller replaced

    25) Boom pins and bushings replaced

    26) Replace hoses wear needed

    27) Replace dust collector hose

    28) Jaws repaired from bent and worn condition – new pins installed

    29) Repaired rod roller system

    30) Replaced Digital X – Y boom angle reader.
  • AdditionalCategory: Drills - Vertical