PORTABLE FABTEC/SUPERIOR T70 VSI WITH 42" UNDER VSI REAR DISCHARGE
CONVEYOR EQUIPPED AS DESCRIBED BELOW:
- WALKWAYS AROUND VSI WITH DIAMOND PLATE FLOOR AND 5" TOE
BOARDS 42" TUBESTEEL HANDRAILS AND ACCESS LADDER.
- 42" UNDER VSI CONVEYOR DISCHARGING OVER REAR OF CARRIER WITH FULL
LENGTH SKIRTBOARD WIPER AND COVER FOR DUST CONTROL:
- VULCANIZED LAGGED HEAD PULLEY SELF CLEANING WING TAIL PULLEY.
- 3 PLY BELT 1/4" COVER; OPTIONAL VULCANIZED SPLICE ~VS~ CLIPS.
- DODGESCM BEARINGS.
- 15 HP TEFC 5207 FALK REDUCER.
- CLOSE SETTING ON CEMA C IDLERS UNDER VSI THEN 36" SPACING.
- PROVISION FOR WATER JETS FOR DUST CONTROL AT UNDER-VSI HOPPER
DISCHARGE END.
- TANDEM AXLE CARRIER 21" WF 68# BEAMS:
- 9700 HUTCH SUSPENSION.
- 22 500# AXLES AND 11:00RX22.5 TIRES.
- AIR BRAKES BRAKE LIGHTS MARKER LIGHTS REFLECTIVE TAPE AND MUD
FLAPS.
- FOUR GROUND SUPPORT STANDS WITH FRONT FOLDING LEGS.
- SAFETY GUARDS SANDBLASTED CHASSIS RUST INHIBITORPRIMER AND TWO
FINISH
COATS.
- GUARDS MAY NOT MEET ALL LOCAL CODES; CUSTOMER IS RESPONSIBLE TO
HAVE GUARDING INSPECTED AND CUSTOMER HOLDS RESPONSIBILITY TO
COMPLY.
INCLUDED OPTIONS:
- 4 LEG PLANT MOUNTED FAB TEC HYDRAULIC STABILIZING SYSTEM:
12 VOLT HYDRAULIC PACKAGE WITH SAFETY LOK CIRCUIT.
70 000 LB CAPACITY HYDRAULIC LEGS WITH HEAVY DUTY FOOT PADS.
- TOOL BOX MOUNTED ON CARRIER:
- VULCANIZED SPLICE ~VS~ STANDARD CLIPS.
- MOTOR SHEAVE.
ELECTRICAL SWITCHGEAR FOR A CANICA 300 HP VSI EQUIPPED AS PER BELOW:
- 60 X 60 HOFFMAN NEMA 4 RATED ENCLOSURE WITH 800 AMP LOCKABLE
OPERATOR
- 400 HP ALTIVAR OR ABB VFD WITH LINE REACTOR
- MOUNTED WITH SUPERIOR SUPPLIED AUX ELECTRICAL CONTROL PANEL
WITHRPM GUAGE VIBRATION DETECTOR (WARNING LIGHT) HOUR METER
OPEN LID SAFETY CUT OFF 2 HP LUBE STARTER OIL SYSTEM HEATER
STARTER AND 15 HP SPARE STARTER (UNDER CRUSHER) WITH TERMINATION
POINTS FOR ALL SAFETY SHUTOFF SWITCHES
- (1) SIZE #2 FOR INTERLOCKED FEED CONVEYOR AND (1) SPARE 20 HP BOTH
WITH 60 AMP RECEPTACLES
- LEG KIT SAFETY START UP HORN
- BUTTONS IN DOOR E-STOP AMP METER HZ METER VOLT METER SPEED POT
- 900 CFM AIR TO AIR EXCHANGER WITH WEATHER COVER
- 5 KVA TRANSFORMER WITH 120V 20A SERVICE OUTLET
- SG SETS OF PLANT 30- FOR OPERATION
PORTABLE FABTEC/SUPERIOR T70 VSI WITH 42" UNDER VSI REAR DISCHARGE
CONVEYOR EQUIPPED AS DESCRIBED BELOW:
- WALKWAYS AROUND VSI WITH DIAMOND PLATE FLOOR AND 5" TOE
BOARDS 42" TUBESTEEL HANDRAILS AND ACCESS LADDER.
- 42" UNDER VSI CONVEYOR DISCHARGING OVER REAR OF CARRIER WITH FULL
LENGTH SKIRTBOARD WIPER AND COVER FOR DUST CONTROL:
- VULCANIZED LAGGED HEAD PULLEY SELF CLEANING WING TAIL PULLEY.
- 3 PLY BELT 1/4" COVER; OPTIONAL VULCANIZED SPLICE ~VS~ CLIPS.
- DODGESCM BEARINGS.
- 15 HP TEFC 5207 FALK REDUCER.
- CLOSE SETTING ON CEMA C IDLERS UNDER VSI THEN 36" SPACING.
- PROVISION FOR WATER JETS FOR DUST CONTROL AT UNDER-VSI HOPPER
DISCHARGE END.
- TANDEM AXLE CARRIER 21" WF 68# BEAMS:
- 9700 HUTCH SUSPENSION.
- 22 500# AXLES AND 11:00RX22.5 TIRES.
- AIR BRAKES BRAKE LIGHTS MARKER LIGHTS REFLECTIVE TAPE AND MUD
FLAPS.
- FOUR GROUND SUPPORT STANDS WITH FRONT FOLDING LEGS.
- SAFETY GUARDS SANDBLASTED CHASSIS RUST INHIBITORPRIMER AND TWO
FINISH
COATS.
- GUARDS MAY NOT MEET ALL LOCAL CODES; CUSTOMER IS RESPONSIBLE TO
HAVE GUARDING INSPECTED AND CUSTOMER HOLDS RESPONSIBILITY TO
COMPLY.
INCLUDED OPTIONS:
- 4 LEG PLANT MOUNTED FAB TEC HYDRAULIC STABILIZING SYSTEM:
12 VOLT HYDRAULIC PACKAGE WITH SAFETY LOK CIRCUIT.
70 000 LB CAPACITY HYDRAULIC LEGS WITH HEAVY DUTY FOOT PADS.
- TOOL BOX MOUNTED ON CARRIER:
- VULCANIZED SPLICE ~VS~ STANDARD CLIPS.
- MOTOR SHEAVE.
ELECTRICAL SWITCHGEAR FOR A CANICA 300 HP VSI EQUIPPED AS PER BELOW:
- 60 X 60 HOFFMAN NEMA 4 RATED ENCLOSURE WITH 800 AMP LOCKABLE
OPERATOR
- 400 HP ALTIVAR OR ABB VFD WITH LINE REACTOR
- MOUNTED WITH SUPERIOR SUPPLIED AUX ELECTRICAL CONTROL PANEL
WITHRPM GUAGE VIBRATION DETECTOR (WARNING LIGHT) HOUR METER
OPEN LID SAFETY CUT OFF 2 HP LUBE STARTER OIL SYSTEM HEATER
STARTER AND 15 HP SPARE STARTER (UNDER CRUSHER) WITH TERMINATION
POINTS FOR ALL SAFETY SHUTOFF SWITCHES
- (1) SIZE #2 FOR INTERLOCKED FEED CONVEYOR AND (1) SPARE 20 HP BOTH
WITH 60 AMP RECEPTACLES
- LEG KIT SAFETY START UP HORN
- BUTTONS IN DOOR E-STOP AMP METER HZ METER VOLT METER SPEED POT
- 900 CFM AIR TO AIR EXCHANGER WITH WEATHER COVER
- 5 KVA TRANSFORMER WITH 120V 20A SERVICE OUTLET
- SG SETS OF PLANT 30- FOR OPERATION
Availability and price subject to change and/or prior sale. Specifications and equipment configuration is subject to change. Please consult a sales professional to ensure that website information is correct and up-to-date.
This is a courtesy price conversion. It may not be exact as the currency conversion rates change. When making a purchase, the original price in the native currency is implied.
Contact Dealer
Fields marked with an * (asterisk) are required.
Price Watch
Subscribe to be notified of price changes on this item.
