The auxiliary water pump works. The door for access to the water pump/nozzle is dented - but can be opened/closed., The rubber bumpers at top of in-feed throat are worn. One chip drum bearing has had the lower housing replaced - unsure of bearing condition - but is not building excessive heat., The access door for the chip accelerator is missing one bolt to secure it (bolt broken off in hole)., Has an auxiliary air compresssor. Battery is missing - it starts and runs well with the pull start. The compressor unloader does not work - it will build air to almost 200 psi then the relief will pop., 250 hour service was performed at current hours. Machine has a radio remote that works. 2 work lights do not work., Some additional plating/supports were added to the chip deflector. There are still some cracks in sheet metal as seen in the pictures., This machine is a drum chipper. There is very little vibration. It has new chip accelerator paddles. There are some cracks in belt shrouds and the chip deflector that have been welded back up., The mill looks good - has new knives and counter knives. Anvil is worn. In-feed area and drum look good. The chains have a lot of wear for the hours on machine. It has a 3 chain feed system., Control panel looks good. Fuel level indicator has intermittant fault. Overall machine seems in good condition., Tires are in good shape. All trailer lights are intact and brakes work. Light bar is held on with pieces of all-thread . All auxiliary switches (chip deflector - feel roller lift - etc) work., None