USED BUNTING- MASTERMAG MODEL EMAX120-CB AIR COOLED ELECTRO SELF-CLEANING CROSSBELT MAGNET EQUIPPED PER THE BELOW: - SUITABLE FOR USE OVER A MAXIMUM 1 200MM (48) WIDE BELT CONVEYOR WITH A PRODUCT DEPTH OF LESS THAN 250MM (10›¼À) THE MAGNET PRODUCES IN EXCESS OF 550 GAUSS AT SUGGESTED OPERATING GAP OF 350-400MM (13.75›¼À-15.75›¼À). MAGNET SHIPPING DIMENSIONS: - 140 X 120 X 60 CM - SHIPPING WEIGHT: 1816KG INCLUDES: - 5KW TRANSFORMER RECTIFIER - CONTINUOUSLY RATED AIR-COOLED TRANSFORMER RECTIFIER TO CONVERT THE 4600V - 3PH - 60HZ AC SUPPLY TO THE NECESSARY DC CURRENT REQUIRED FOR MAGNET OPERATION - MAXIMUM OUT-FEED CONVEYOR BELT WIDTH: 48›¼À BENEFITS OF THE EMAX AIR COOLED ELECTROMAGNET: - ELECTRO-MAGNET THAT IS LESS EXPENSIVE THAN A PERMANENT MAGNET - THE E-MAX USES COOLING VIA AIR CONVECTION NOT OIL = LESS MAINTENANCE & NO TANK ANGLE INSTALLATION REQUIREMENT - CAN BE USED ON FLAT OR ANGLED CONVEYORS WITH THE ONLY CHANGE REQUIRED IS THE HANGING CHAIN LENGTH - THE E-MAX HAS A RECTANGULAR STEEL CORE- OTHER OIL COOLED DESIGNS HAVE CIRCULAR CORES - THE E-MAX COIL IS WOUND IN ANODIZED ALUMINUM FOIL RATHER THAN ROUND NOMEX WRAPPED ALUMINUM WIRE IN THE CASE OF OIL COOLED COILS - ANODIZED ALUMINUM FOIL IS EXPENSIVE BUT DOES MAKE FOR A MORE COMPACT COIL WITH NO AIR GAPS IN THE WINDING VERSUS ROUND WIRE USED IN OIL COOLED COILS - THE E-MAX WILL EXTRACT A 23 KG DIGGER TOOTH TYPICALLY 330 X125 X 100MM AT 350MM GAP AND DEPENDENT ON THE APPLICATION MAY WELL REMOVE THEM AT 400MM - THE E-MAX IS DIMENSIONALLY SMALLER & WEIGHS CONSIDERABLY LESS THAN AN OIL COOLED ELECTROMAGNET